Whole house got rewired from the panel out. The old service was undersized and the branch circuits were a mix of knob-and-tube, ungrounded romex, and aluminum patches. New 200-amp panel went in, every circuit was pulled and replaced, and we worked off the permit room by room. My son helped on outlets and low-voltage runs once the rough-in passed. Stickers in the windows tell the story.
-
After New main panel landed and signed off. The old service was a mess of mismatched circuits.
-
During My son working on a low-voltage outlet. Good job for a careful set of hands.
-
During My son wiring an outlet by worklight. We worked off a single circuit at a time so nothing got crossed.
-
During Stripping wires for the next box. Strip length matters — too long and the screws don't bite right.
-
Rough electrical and plumbing inspection stickers in the window. Permits keep the resale clean.
Want a Plan for Your Project?
Send photos and a few sentences. I'll send back a written diagnostic — what's broken, what it'll cost, and what to DIY vs. hire. $9.99, in your inbox in minutes.
Get a Diagnostic Report — $9.99 →